Remove all items from the packing tube. You should have the following before beginning:
* (2) Gas springs (RT-QL-120-10A) – Be sure to cycle them a few times before installing.
* (4) 3/16″- #1steel rivets (used on hood brackets)
* (2) ball-studs and washers
* (2) brackets used on hood frame
* Printed Color Instructions
* Gas Spring locking clips – (Already installed in the gas spring ball-ends-ball-studs/washers

Please gather the following tools before you begin the installation:
* Power Drill
* 3/16″ drill bit
* Fine permanent marker or felt tip pen
* Tape measure or ruler
* Masking tape
* Hammer & center punch
* Rivet gun,capable of 3/16″ rivets (most brands can handle this size)

A. Leave your hood closed.
B. Using a piece of masking tape and a permanent marker, carefully measure from the hood’s corner (near hinge and windshield) and along the fender line. Wrap the end of the tape measure over the corner lip and place a mark on the hood masking tape at 14″

Download