Free PDF Manual Guide

Installation Procedure:
- Open trunk hatch, and pull off cover for the strut tower bolts.
- Remove the 14mm OEM nuts (requires 14mm end wrench and 5mm Allen key)
- Once removed, thread on provided nut (16mm).
- Tighten down bolt to 20lbs with 16mm End-wretch.

Packing Tips
• Do not overstuff or over-load Saddlebag. The whole concept here is to tour with the lightest load possible. Go lighter, go faster.
• See fig A. Pack sleeping bag first by pulling through one side opening and out the other to distribute volume evenly. Then, pack other items to evenly distribute the load from [...]

POWER STEERING OIL PUMP DRIVE BELT TENSION CHECK AND ADJUSTMENT : With your finger tip lightly tap the centre of the belt between the pulleys in the location shown by the arrow in the illustration and then measure the belt vibration frequency. Apply 98N of pressure against the location between the pulleys shown by the [...]

Part content: ignition coil and igniter, charging system, junction connector, combination meter, engine control, air injection control driver data link connector 3, engine control module. Skid control ECU with actuator suspension, camshaft timing control valve LH, Multiplex Communication System. Engine Immobilisers System.

Fuel system overview : Demand-Controlled Fuel System, Low Pressure System, High Pressure System. Fuel System Components : Fuel Pump Control Module J538, Transfer Fuel Pump G6, High Pressure Fuel Pump with Fuel Pressure Regulator Valve N276, High Pressure Fuel Pump, High Pressure Fuel Pump Operation, Low Fuel Pressure Sensor G410, Fuel Pressure Sensor G247, Cylinder [...]

These instructions are only a guide to proper installation. It is the technicians’ responsibility to confirm all connections are correct, use of the proper factory service manual is recommended. We recommend that only a competent and qualified mechanic perform this installation
1) Disconnect negative terminal of battery.
2) Confirm correct plug, pin # and wire colors on [...]

Preparation Steps for Fuel System Installation
A: Adjust both seats to full forward position with seat backs in full upright position.
B: Disconnect the negative battery cable.
C: Remove the 5 rear interior panels starting with the long piece across the width of the car just beneath the rear glass. Next remove the two flat panels located behind [...]

Conduct the tightening procedures by confirming the turning angle of the crankshaft pulley bolt referring to the gauge indicated on the belt cover. Install V-belt air conditioning compressor drive belt tensioner and V-belt cover. cylinder block : check for cracks and damage visually, especially, inspect important parts by means of red lead check. Check the [...]

Remove the handle and mount it to the side of the engine with three, 3/8″ bolts. Be careful not to stretch the handle wires and cables. The washers and nylock nuts installon the inside of the handle mount near the slots. The handle bolts must be snug enough to hold the handle firmly, but yet [...]

1. Remove contents and check for damage. Verify all parts are present. Read instructions completely before installation.
2. Locate driver side mounting locations on vehicle (See Figure 1and 2). Repeat for passenger side.
3. Attach driver side front and rear mounting brackets to underside of rocker panel as shown using M8 hex bolts, 5/16” flat washer and [...]