This part is street legal in all 50 states for use on 1994-2001 Acura Integra GSR 1.8L Vtec.
Throttle Body Kit Contents:
1 – Throttle body to manifold gasket
1 – Fast idle thermo valve o-ring with white stripe
1 – Fast idle thermo valve o-ring with red stripe
1 – Fast idle thermo valve o-ring with green stripe
1 – MAP sensor o-ring with blue strip
1 – E.O. # fan shroud decal

INSTALLATION INSTRUCTIONS
1. Please read through the entire instruction sheet to familiarize yourself with the parts of the vehicle the installation will deal with.
2. Start the engine and check for loose connections or coolant/vacuum leaks, etc.
3. Disconnect the negative battery terminal.
4. Remove the air filter duct, all vacuum hoses, water (coolant) hoses and electrical connectors from the stock throttle body. Mark all hoses and wires to ensure that they are installed correctly on the new throttle body. Note: Enginecoolant may run from the hoses once removed.
5. Disconnect the throttle linkage by opening the throttle manually and slipping the cable from the cam groove on the linkage.
6. Remove the four nuts securing the throttle body to the intake manifold and remove it.
7. Remove the MAP (see Figure 1 for MAP sensor location) sensor from the factory throttle body. Use the new O-ring with the blue stripe from the kit contents to seal the MAP sensor to the throttle body. Attach the MAP sensor to the new throttle body using the factory screws.
8. Remove the idle air control (IAC) motor (see Figure 1 for IAC motor location) from the factory throttle body. Using the factory bolts and the O-rings supplied in the kit, attach the IAC to the new throttle body. The o-rings are color-coded so refer to Figure 1 for proper installation. Torque down bolts to 10 N·m or 7 lbf·/ft. Note: To achieve the maximum benefits when re-using the factory intake manifold, you should match the opening on the intake manifold to the size of the new throttle body bore. The manifold should be hand-ground OFF the engine and thoroughly cleaned prior to re-installation. If using Edelbrock Victor X PN 4760, 4761 or 47601, no grinding is needed. These manifolds are already bore-matched to this throttle body. Refer to the OEM owner’s manual for removal/installation procedure of the intake manifold. Use the gasket as a template to mark the manifold for grinding…

Download