Free PDF Manual Guide

Part Content:
This will also space out the entire wheel, widening the track width of the vehicle. Fender clearances should be checked on lowered cars, and longer lug studs or wheel bolts are usually required. Note: The Wheel Industry Council has issued guidelines advising wheel spacers not be used. It is the responsibility of the customer [...]

The COMP Cams® Acura/Honda B-Series VTEC valve spring set (Fig. A) utilizes dual springs on the intake side and a single spring on the exhaust side. Below are the information and diagrams to ensure correct installation.
Installation Instructions:
Dual Intake Spring
Installed Height: 60lbs at 1.375
Open Height: 220 lbs at .875
Coil Bind Height: .815
Spring Rate: 300 lbs per [...]

Removal
1. Relieve the fuel pressure in the system by loosening the banjo bolt on the top of the fuel filter. Disconnect the fuel line from the fuel rail. It is a good idea to replace the washers. Disconnect the fuel harness holder and unbolt. Disconnect the hoses from the fuel pressure regulator (FPR).
2. Disconnect intake [...]

Preparation Steps for Fuel System Installation
A: Adjust both seats to full forward position with seat backs in full upright position.
B: Disconnect the negative battery cable.
C: Remove the 5 rear interior panels starting with the long piece across the width of the car just beneath the rear glass. Next remove the two flat panels located behind [...]

1. The filter is located behind the glove compartment. Unscrew the 2 screws at the bottom of the glove box cover to loosen the it. Remove glove box and set it aside.
2. Cut the plastic cover along the dotted lines shown and remove it. Dispose off plastic cover, it is no longer needed. This exposes [...]

Thank you for purchasing the Comptech Icebox Intake kit for the Acura TSX. All components have been designed and manufactured utilizing the latest in technology and materials. Please take a moment to read this instruction manual and warranty information page thoroughly before starting any work. Remember to always use jackstands to support the vehicle when [...]

The Acura® electro includes a microprocessor-controlled motor. Four models cover the volume range 0.5 to 1000 µL. The intelligent software allows for programming five pipetting modes in any available range. To increase pipetting flexibility, the electronic control unit accommodates all interchangeable volume modules (lower assembly).

After a three-year hiatus, the Type-S reintegrates the TL fold. For 2007, this version features a 3.5-litre V6, rather than a 3.2-litre. The engine makes 286 horsepower and can be mated to either a six-speed manual transmission or a five-speed automatic. The Type-S also comes specially equipped with exclusive wheels, front four-piston Brembo brake callipers, [...]

Thank you for purchasing the Comptech Icebox Cold Air Intake for the 2002–2003 Honda Civic-Si and 2001 – 2003 Acura RSX. All components have been designed and manufactured utilizing the latest in technology and materials. Comptech recommends that you read through these instructions before starting installation and that you use an Acura Factory Shop Manual [...]

What is the SmartMAP?
The SmartMAP model SS-300 replaces the check valve and restrictor assembly used by most Honda/Acura turbo and supercharger kits and prevents the engine computer (ECU) from shutting down the engine when the manifold pressure is above atmospheric (boost).
How does the SmartMAP work?
The SmartMAP connects inline with the stock (OEM) manifold absolute pressure [...]