Free PDF Manual Guide

The HALTECH E11 is a powerful “real-time” programmable fuel injection system computer designed for those seeking optimum performance. With the large number of outputs available for controlling ignition and fuel, the E11 is well equipped to run engines with sequential fuel and modern multi-coil ignition systems.

If a lateral tire force is acting on the wheel, a braking or accelerating force (tangential tire force) can only build up in a longitudinal direction up to the maximum total force (resulting force on surface). When this is reached, the wheel locks or spins. Conversely, only a limited lateral cornering force (lateral tire force) […]

How to determine what type of brake calipers and ABS sytem is fitted. During development of the cruise control for the R1150GS we have been aware that there are two different types of front brake caliper and two different ABS systems fitted to this model, and some bikes without ABS. In order to supply the […]

This guide focuses on the standard installation of an SMT6 unit. For help with non-standard tuning applications, such as the turbo nitrous control, please refer to the Application Notes. Application Notes can be found under the “Downloads” section on our website www.perfectpower.com.

• Place the bike on the center stand and remove the current shock absorber.
• Place the Hyperpro shock in the bike, type 461 with reservoir as shown in the picture. If your shock is equipped with the optional hydraulic preload adjuster place the banjo bolt of the HPA to the right side of the bike.

What’s Included:
1. The Model 80 enclosure bottom
2. The Model 80 vinyl covered enclosure top
3. Alumapro Alusonic 8 subwoofer (optional)
4. Subwoofer grille (optional)
5. Terminal cup
6. Self-adhesive gasket foam
7. Trim cord
8. (8) #10 x ¾” Phillips pan-head screws
9. (4) #14 x 1” hex-head sheet metal screws
10. (4) 1” fender washers
11. (4) 3/8 ” thick rubber washers
12. (12) […]

A phone prewire extension harness(center console to left side trunk, illustration 1) must be installed on the E46 (328i, 328iA) produced the first two weeks of 6/98 if the phone kit is being installed. The phone prewire option SA640 was not installed on vehicles produced during the first two weeks of 6/98. E46’s produced after […]

Most 17” wheels will clear the outer diameter of the caliper for a 328mm or 332mm rotor kit. For a 355mm kit, a minimum 18” wheel is typically required, and for a 380mm rotor kit, a minimum 19” wheel is needed. The more critical clearance, however, is the gap between the spokes of the wheel […]

Most 18” wheels will clear the outer diameter of the caliper on a 355mm kit. However, the more critical clearance is the gap between the spokes of the wheel and the face of the caliper. Do not assume that a 19”, 20” or even 24” wheel will clear the face of the caliper. The actual […]

BMW of North America, Inc. has voluntarily initiated a recall campaign which involves the oxyge sensor wiring harness of the affected vehicles. The potential defect is due to a possible incorrect oxygen sensor harness routing during production. The oxygen sensor harness may have been mistakenly secured with clips to the exhaust heat shield and/or to […]