Free PDF Manual Guide

Evaporator Case Assembly The evaporator case assembly is attached to the engine side of the dash panel. The case is a two-piece molded construction, one piece of which forms a cover over the evaporator core. An integral vacuum reservoir is part of the cover housing. This reservoir and the vacuum motor, which operates the outside/recirc […]

The wide ratio version is available for all F Series vehicles over 8500 lbs GVW all engines 6007 except F Super Duty Commercial Stripped Chassis equipped with a diesel engine The close ratio version is available only in F Series vehicles with a 7 3L diesel engine and a GVW over 8500 lbs.

In fact the Ford Focus makes you question what is a small car these days? In a practical departure from most new cars the glove box can take a full size street directory and have room left over. This makes up for the narrow front door pockets and small centre armrest compartment. While there aren’t […]

Remove the attached body, if applicable. Remember to disconnect all electrical connections to the body, and fuel filler tube, before removing the body. The installation can also be completed using a lift to raise the vehicle. If using a lift, chassis body removal may not be necessary but removal of rear wheels will aid in […]

ACCEL recommends using a 180 degree thermostat in most applications. Place your thermostat and gasket onto your manifold, put your thermostat housing onto the manifold and bolt in place. When installing your fuel injectors, be careful not to cut the O-Rings. A small amount of oil on each O-Ring will aid in the assembly. Please […]

Ford Motor Company vehicles are designed and tested for safe operation with properly installed and properly used land mobile/amateur radio communication equipment with up to 100 Watt transmitter power.
Special design considerations are incorporated into all Ford vehicle electronic systems to provide immunity to radio frequency signals. To maintain compatibility with vehicle electronic systems, mobile two-wayradio […]

Shopping list from FORD dealer, $15.00 for 2 sets of heater hose o-rings and snap clips, $40.00 heater core, (cheaper at the dealer but no warrantee, aftermarket parts store model preferred by many @ $55) insulated foam tape to wrap new core with (parts dept just gave me what I needed), and a gallon of […]

If you are attempting to install a 1990-1993 steering wheel in a 1987-1989 car, then the steering column must also be changed. All
connections will hook up in the steering column except for the harness from the steering wheel, which provides the horn and cruise control signal. The windshield wipers will not work if the 1990-1993 […]

Application: 2005 Ford Mustang GT 4.6L 3 Valve with Manual Transmissions Only. Before installing your Roush Performance Products, please read the installation manual and verify that all items are present. Premium fuel (91 octane minimum) is required to prevent “spark-knock” or detonation under certain operating conditions.

This ROUSHcharger kit is designed and tested to function properly only on vehicles as they are equipped from the factory (completely stock powertrains). The use of aftermarket parts and equipment such as: cams, headers, nitrous oxide systems, other bolt-on performance parts, or any other performance parts not sold by, manufactured by, or approved of in […]