Free PDF Manual Guide

1. Turn the ignition OFF and disconnect the vehicle’s negative battery cable.
2. Disconnect the air temperature sensor electrical connection as shown.
3. Unclip the battery cable from the air inlet duct as shown.
4. Loosen and remove the two bolts that secure the air inlet duct as shown.
5. Remove the air inlet duct.

The information in this installation instruction is intended for use only by skilled technicians who have the proper tools, equipment, and training to correctly and safely add equipment to your vehicle. These procedures should not be attempted by “do-it-yourselfers.”
NOTE: These installation instruction show the left fog light begin installed. The same procedure applies to installing [...]

This product is to be used ONLY on the Honda S2000 and is intended to provide increased driver support when using the stock lap belt and shoulder harness. It is NOT to be used as a replacement for competition belts or at any event where 4 or 5-point restraint systems are required. This product uses [...]

his kit is designed to fit both the 120&160 engine platforms. The only difference you will find between the 120 and the 160 engine is the direction the cable adjustment block is installed on the engine block.
1. Remove the stamped factory linkage plate and related hardware.
2. Check your carburetor and confirm the throttle arm (black [...]

STEP 1. Remove the contents from the box and check for any damage. Verify all parts against the parts list.
STEP 2. Read and understand instructions completely before beginning installation.
STEP 3. Determine passenger and driver mount brackets from figure above.
STEP 4. Remove the (16) push type retainers and (2) 6mm bolts from the lower splash shield. [...]

Tools Needed To Complete This Install Hand tools needed Accessory tools needed to test and to remove radio wire the new radio PLUS: Wire ties or electrical tape: to neatly bundle and organize your wires for a professional appearance. TOOL TIPS: Small Battery: use a battery to test speaker wires. Touching the (+) positive and [...]

Congratulations! You have just purchased the best engineered, dyno-prove intake system available. Please check the contents of this box immediately. Report any defective or missing parts to the Authorized Injen Technology dealer you purchased this product from. Before installing any parts of this system, please read the instructions thoroughly. If you have any questions regarding [...]

HONDA CLAIMER RULE – For GX160 QMA Type Engines
1. Claims will be from within the same division of class only (Junior, Senior, Light GX160, Heavy GX160).
2. Engine may be claimed for $450.00 cash or certified funds or a complete new (still in box) same type Honda engine. This is the option of the person being [...]

Before beginning your installation, please note the following:
• Though our products allow for user friendly installation, Supreme Legends USA recommends all installation of our product to be done by a qualified mechanic or individual.
• Some controls may require additional components not included with your kit. Some instructions may or may not be included such as [...]

The HONASX can either provide up to 2 auxiliary audio inputs to your Honda radio for use with any device that has RCA line level outputs, or provides 1 auxiliary audio input and allows interfacing an aftermarket CD Changer. AUX 1 is the 8 pin DIN to RCA cable which plugs into the 8 pin [...]