Free PDF Manual Guide

INSTALL FLYWHEEL
1. Drain 20% of the oil from the bike first.
2. Shut the gas supply off on the bike, then lay it over on its side. A small amount of gas will leak from the overflow tubes when the bike is first laid down.
3. Remove shifter.
4. Remove bolts holding the side cover on (no need [...]

1. POSITION RACK SQUARELY ON TRUNK LID AS FAR FORWARD AS POSSIBLE WITHOUT ALLOWING ENDS TO RUB ON PASSENGER BACKREST SECTION.
2. LIFT RACK SLIGHTLY AND PLACE THREE 3″ – 4″ PIECES OF MASKING TAPE UNDER EACH OF THE REAR LEGS. (FIG B).
3. USE A MARKING PEN TO OUTLINE EACH OF THE FOUR MOUNTING LEGS ONTO [...]

This kit has been engineered to be an easy, bolt on upgrade to your standard Jackson Racing supercharger kit. It will raise your boost approximately 2 psi. As such, it has been designed to be a “Race Only” kit. Because of the “Race Only” design criteria, the C.A.R.B. Exemption Order number supplied with your Jackson [...]

STEP 1: Adjust hood until proper alignment with matching panels is achieved.
STEP 2: Adjust primary latch until it fits into the bar on the hood. Make sure when the hood is closed you can hear the latch “click” onto the hood.
STEP 3: After you here it click, test it to be sure it’s working properly [...]

Locate the vacuum – There is a rubber bung over a spigot on the inlet side of the front carburetor, as shown below left. Remove this bung and then press the Damper Elbow, part number 4, onto the spigot. The RMV can be positioned under the seat, as shown in the third picture. The more [...]

Preparation Steps for Fuel System Installation
A: Adjust both seats to full forward position with seat backs in full upright position.
B: Disconnect the negative battery cable.
C: Remove the 5 rear interior panels starting with the long piece across the width of the car just beneath the rear glass. Next remove the two flat panels located behind [...]

1. Remove contents and check for damage. Verify all parts are present. Read instructions completely before installation.
2. Locate driver side mounting locations on vehicle (See Figure 1and 2). Repeat for passenger side.
3. Attach driver side front and rear mounting brackets to underside of rocker panel as shown using M8 hex bolts, 5/16” flat washer and [...]

Installation Guide:
1. Removing factory tail light. Seat removal needed (2 alien bolts and slide it outj.Upper tail needs to be removed (4 alien bolts and gently pull up and back – remove left and right side covers first). Disconnect factory tail light harness.
2. Unscrew two screws holding bracket to upper tail. Remove bracket and swap [...]

1) Disconnect negative battery cable and ground strap at transaxle. Disconnect positive battery cable. Remove battery and battery base. Remove drain plug, and drain transaxle fluid (remove fill plug to speed draining). Install drain plug with NEW washer, and tighten plug to specification. See TORQUE SPECIFICATIONS TABLE at the end of this article.
2) Disconnect wiring [...]

Remove the bezel that surrounds the climate control and extends behind the transmission shifter. To do this, grasp the bezel behind the shifter and release the first clip. In the upper-right corner of the bezel, use the Dash Trim tool to work loose the remaining ten (10) clips that hold the bezel in place. Note: [...]