TURNING THE RADIO ON OR OFF:
Turn on/off/volume control: (control #1 on attached
radio diagram)
Clockwise = on
Counterclockwise = off

SELECTING ZONE (BANK):
The radio is equipped with three zones or banks labeled A, B, and C, which are controlled by the toggle switch (control #4).
A = (Always) it the primary operational setting and should be used for routine operation.
B = (Backup) it is the redundant backup zone should the A-bank fail. If your radio says “Site Trunking” or “Fail Soft” in LED screen switch to the B-bank. C = (Cause) switch to this bank beCause someone told you to.
SELECT THE DESIRED MODE (TALKGROUP): Modes are also known as channels or talkgroups. Each radio can have up to 16 talkgroups per bank. (See the talkgroup listings and key for your radio group.) Select the desired talkgroup with mode control knob (#2). The LED display shows the talkgroup name.

SETTING VOLUME:
1. Turn the radio on and select zone and mode (bank and talkgroup)
2. Listen for a transmission, then adjust volume control to a comfortable level

RECEIVING:
1. Turn radio on.
2. Select zone and mode (bank and talkgroup)
3. Set volume. You are ready to receive on selected zone and mode.

TRANSMITTING:
1. Turn radio on.
2. Select zone and mode (bank and talkgroup)
3. Set volume.
4. Monitor selected talkgroup to be sure no one else is using it.
5. When channel is clear, depress and hold the PTT (push to talk) button (#10) to talk (transmit).

Download